LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Lighting System - DTC B3891 To DTC C0297 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Headlamps Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the scan tool Headlamps On Switch parameter changes between Active and Inactive while commanding the headlamp ON and OFF with the turn signal/multifunction switch.
    • If the parameter does not change 

      Refer to Turn Signal/Multifunction Switch Malfunction.

    • If the parameter changes 
  3. Verify the scan tool Automatic Headlamps Disable Switch parameter changes between Active and Inactive while commanding the automatic lamp control ON and OFF with the turn signal/multifunction switch.
    • If the parameter does not change 

      Refer to Turn Signal/Multifunction Switch Malfunction.

    • If the parameter changes 
  4. Verify the scan tool Headlamps Flash Switch parameter changes between Active and Inactive while commanding the flash to pass ON and OFF with the turn signal/multifunction switch.
    • If the parameter does not change 

      Refer to Turn Signal/Multifunction Switch Malfunction.

    • If the parameter changes 
  5. Verify the scan tool High Beam Select Switch parameter changes between Active and Inactive while commanding the high beams ON and OFF with the turn signal/multifunction switch.
    • If the parameter does not change 

      Refer to Turn Signal/Multifunction Switch Malfunction.

    • If the parameter changes 
  6. Verify the left low beam headlamp turns ON and OFF when commanding the appropriate Low Beam Lamp ON and OFF with a scan tool.
    • If the left low beam headlamp does not turn ON and OFF 

      Refer to Headlamps Malfunction - Low Beam.

    • If the left low beam headlamp turns ON and OFF 
  7. Verify the right low beam headlamp turns ON and OFF when commanding the appropriate Low Beam Lamp ON and OFF with a scan tool.
    • If the right low beam headlamp does not turn ON and OFF 

      Refer to Headlamps Malfunction - Low Beam.

    • If the right low beam headlamp turns ON and OFF 
  8. Verify the high beams turn ON and OFF when commanding the High Beams ON and OFF with a scan tool.
    • If the high beams do not turn ON and OFF 

      Refer to Headlamps Malfunction - High Beam.

    • If the high beams turn ON and OFF 
  9. All OK.
scientia non olet · About LEMON Manuals