Circuit/System Testing

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the A14P Seat Lumbar Support Pump - Passenger. It may take up to 2 min for all vehicle systems to power down.
Test for less than 10 Ω between the ground circuit terminal 4 and ground.
- If 10 Ω or greater
1. Ignition OFF.
2. Test for less than 2 Ω in the ground circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, repair the open/high resistance in the ground connection.
- If less than 10 Ω
Connect a test lamp between control circuit terminal 2 and control circuit terminal 5, ignition ON.
Verify the test lamp turns ON when pressing the lumbar switch in the Forward and Rearward directions.
- If the test lamp remains OFF during either of the commands
1. Ignition OFF, remove the test lamp, disconnect the X2 harness connector at the S64P Seat Adjuster Switch - Passenger.
2. Test for infinite resistance between each control circuit and ground.
  - If less than infinite resistance, repair the short to ground on the circuit.
  - If infinite resistance
3. Test for less than 2 Ω in each control circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, test or replace the S64P Seat Adjuster Switch - Passenger.
- If the test lamp turns ON during each of the commands
Test or replace the A14P Seat Lumbar Support Pump - Passenger.