Component Testing
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Easy Entry Switch
- Ignition OFF, disconnect the harness connector at the appropriate S115 Easy Entry Switch.
- Test for infinite resistance between the B+ terminal A and each signal terminal with the switch in the open position.
- If less than infinite resistance
Replace the S115 Easy Entry Switch.
- If infinite resistance
- If less than infinite resistance
- Test for less than 2 Ω between the B+ terminal A and each signal terminal with the appropriate switch in the closed position.
- If 2 Ω or greater
Replace the S115 Easy Entry Switch.
- If less than 2 Ω
- If 2 Ω or greater
- All OK.