LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Front Drive Axle) >> Diagnostic Information and Procedures >> Noisy When Coasting

Noisy When Coasting

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Cause Correction
NOTE:

Inspect for the proper gear oil levels prior to performing system diagnosis. Refer to Front Axle Lubricant Level Inspection 

Worn wheel drive shaft constant velocity joints Replace the wheel drive shafts as required. Refer to Front Wheel Drive Shaft Replacement - Left Side , or Front Wheel Drive Shaft Replacement - Right Side .
Bearing noise within the differential assembly A grinding or roar type noise will increase or decrease relative to the vehicle speed.
  1. Check for the proper fluid level. Fill as required.
  2. If the noise continues, replace the carrier unit. Refer to Front Differential Carrier Assembly Replacement (LGX or LF4) Front Differential Carrier Assembly Replacement (LCV or LTG) .
Gear set whine noise within the differential assembly A whine type noise will increase or decrease relative to the vehicle speed, approximately 80-96 km/h (50-60 mph). Typical causes of a gear set whine type noise may include incorrect backlash and/or pinion depth adjustment or worn or scored gear set teeth.
  1. Check for the proper fluid level. Fill as required.
  2. Replace the carrier unit. Refer to Front Differential Carrier Assembly Replacement (LGX or LF4) Front Differential Carrier Assembly Replacement (LCV or LTG) .