Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the brake caliper guide pins, seals and brake pad springs for damage and/or corrosion. Refer to Front Disc Brake Mounting and Hardware Inspection .
- Apply a thin coat of high temperature silicone brake lubricant the brake caliper guide pin.
- Install the lower brake caliper guide pin (1) to the guide pin seal (2).
- Ensure the guide pin seal is fully seated in the groove of the brake caliper guide pin.
- Install the lower guide pin and seal to the brake caliper bracket.
- Ensure the guide pin seal is fully seated in the groove of the brake caliper bracket.
- Apply a thin coat of high temperature silicone brake lubricant the brake caliper guide pin.
- Install the upper brake caliper guide pin (1) to the guide pin seal (2).
- Ensure the guide pin seal is fully seated in the groove of the brake caliper guide pin.
- Install the upper guide pin and seal to the brake caliper bracket.
- Ensure the guide pin seal is fully seated in the groove of the brake caliper bracket.
- Install the brake pad springs (1).
- Install the outer brake pad (1).
- Install the inner brake pad (2).
- Install the brake caliper to the caliper bracket.
- Using a backup wrench on the brake caliper guide pins, install the brake caliper guide pin bolts (1) and tighten to 28 N.m (21 lb ft).
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Non V-Series)Tire and Wheel Removal and Installation (V-Series) .
NOTE:
The lower brake caliper guide pin is equipped with a bushing.
CAUTION:
Refer to Fastener Caution .