Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the power brake booster vacuum hose and check valve assembly to the vehicle.
- Connect the vacuum pipe (1) to the power brake booster vacuum hose.
- Install the power brake booster vacuum hose to the vacuum port on the intake manifold and connect the quick connect (1).
- Install the power brake booster vacuum hose to the clip (1).
- Install the power brake booster vacuum hose quick connect (1) to the power brake booster vacuum pump.
- Install the power brake booster vacuum sensor and hose (1) to the power brake booster.
- Connect the power brake booster vacuum sensor electrical connector.
- Install the outer fuel pump insulator. Refer to Fuel Pump Insulator Replacement (Outer) .
- Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
NOTE:
A small amount of denatured alcohol may be used as a lubricant for assembly. Do not use soap.