Circuit/System Verification
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition » On / Vehicle » In Service Mode
- Operate the component:Trunk Lid»Closed
Verify the scan tool parameter:Rear Closure Ajar Switch =Inactive
- If not the specified state
Refer to: Circuit/System Testing
- If the specified state
- If not the specified state
- Operate the component:Trunk Lid»Ajar
Verify the scan tool parameter:Rear Closure Ajar Switch =Active
- If not the specified state
Refer to: Circuit/System Testing
- If the specified state
- If not the specified state
- All OK.