Windshield Washer Solvent Container Filler Tube Replacement (Coupe)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Washer Solvent Container Filler Tube (Coupe)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Open the hood. Remove the five passenger side push in retainers for the air inlet grille panel then gently reposition the panel upward to access the tube retainer. Refer to Air Inlet Grille Panel Replacement (Coupe) .
1	Windshield Washer Solvent Container Filler Tube Bolt CAUTION: Refer to Fastener Caution . Tighten 6 N.m (53 lb in)
2	Windshield Washer Solvent Container Filler Tube Procedure Pull inboard on the solvent container filler tube in order to disconnect the filler tube from the windshield washer solvent container grommet. Make sure the windshield washer solvent container filler tube is fully inserted before tightening the fastener.

Callout

Component Name

Preliminary Procedures

Open the hood.
Remove the five passenger side push in retainers for the air inlet grille panel then gently reposition the panel upward to access the tube retainer. Refer to Air Inlet Grille Panel Replacement (Coupe) .

Windshield Washer Solvent Container Filler Tube Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
6 N.m (53 lb in)

Windshield Washer Solvent Container Filler Tube

Procedure

Pull inboard on the solvent container filler tube in order to disconnect the filler tube from the windshield washer solvent container grommet.
Make sure the windshield washer solvent container filler tube is fully inserted before tightening the fastener.