Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Starter Solenoid Cable - Install
- Install the retainers
- Starter Solenoid Cable - Install
- Battery Positive Cable - Install
- Battery Fuse Block Battery Positive Cable Nut - Tighten 15 N.m (11 lb ft)
- Power Distributor Fuse Block Cover - Install
- Install the retainers.
- Raise and support the vehicle. Lifting and Jacking the Vehicle (Base)Lifting and Jacking the Vehicle (V-Series)
- Starter Solenoid Cable - Install
- Fastener Tighten 9 N.m (80 lb in)
- Starter Solenoid Cable Nut Tighten 12.5 N.m (111 lb in)
- Starter Heat Shield-Install Starter Shield Replacement (LGX)
- Lower the vehicle.
- Air Inlet Grille Panel-Install Air Inlet Grille Panel Replacement (Sedan)Air Inlet Grille Panel Replacement (Coupe)
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution .