LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Solenoid Cable Replacement (LF4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pre-Fuse Block
    GM2829735Courtesy of GENERAL MOTORS COMPANY
  1. Attach the following to the pre-fuse junction block:
    • Starter Solenoid Cable (5)
    • Battery Positive Cable (4)
      • CAUTION:

      Refer to Fastener Caution .

    • Battery Positive Barrel Fastener (3). Tighten to 15 N.m (11 lb ft).
    • Pre-Fuse Block Cover (2)
    • Battery Jumper Post Cover (1)
    2. Fig 2: Starter Solenoid Cable Retainer Behind Generator
    GM3556456Courtesy of GENERAL MOTORS COMPANY
  2. Wiring Harness Retainer - Engage
    3. Fig 3: Starter Solenoid Cable Retainer
    GM3556460Courtesy of GENERAL MOTORS COMPANY
  3. Wiring Harness Retainer - Engage
    4. Fig 4: Starter Solenoid Cable Retainers Around Transmission Housing
    GM3556461Courtesy of GENERAL MOTORS COMPANY
  4. Wiring Harness Retainer - Engage
    5. Fig 5: Starter Solenoid Cable
    GM3556462Courtesy of GENERAL MOTORS COMPANY
  5. Connect the starter solenoid cable connector (1) to the engine harness connector (2).
    6. Fig 6: Starter Solenoid Connector
    GM4277291Courtesy of GENERAL MOTORS COMPANY
  6. Starter Solenoid Connector - Connect
  7. Starter Solenoid Cable - Install
  8. Starter Solenoid Cable Nut - Install and tighten 12.5 N.m (111 lb in)
  9. Starter - Install - Starter Replacement (LF4 - Manual Transmission) Starter Replacement (LF4 - Automatic Transmission) 
  10. Connect the negative battery cable. Battery Negative Cable Disconnection and Connection 
scientia non olet · About LEMON Manuals