Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Starter Solenoid Connector

Courtesy of GENERAL MOTORS COMPANY

Starter Solenoid Connector - Connect
Starter Solenoid Cable - Install

CAUTION:

Refer to Fastener Caution

Starter Solenoid Cable Nut - Install and tighten 12.5 N.m (111 lb in)
Starter - Install

Fig 2: Starter Solenoid Cable Retainer Bolt

Courtesy of GENERAL MOTORS COMPANY

Starter Solenoid Cable Retainer Bolt - Install and tighten 6 N.m (53 lb in)
Starter Mounting Bolt - Install and tighten 58 N.m (43 lb ft)

Fig 3: Starter Heat Shield

Courtesy of GENERAL MOTORS COMPANY

Starter Heat Shield - Install - Starter Shield Replacement (LF4)

Fig 4: Turbocharger Oil Return Pipe

Courtesy of GENERAL MOTORS COMPANY

Turbocharger Oil Return Pipe - Install - Turbocharger Oil Return Pipe Replacement (Bank 1)Turbocharger Oil Return Pipe Replacement (Bank 2)

Fig 5: Engine Mount Bracket

Courtesy of GENERAL MOTORS COMPANY

Engine Mount Bracket - Install - Engine Mount Bracket Replacement - Left Side (LF4)
Lower the vehicle.

Fig 6: Starter Solenoid Cable Connector

Courtesy of GENERAL MOTORS COMPANY

Connect the starter solenoid cable connector to the engine harness connector. <p01>

Fig 7: Air Cleaner Assembly

Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Assembly - Install - Air Cleaner Assembly Replacement (LF4)
Connect the negative battery cable. Battery Negative Cable Disconnection and Connection