Removal Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection
- Air Cleaner Assembly - Remove - Air Cleaner Assembly Replacement (LF4)
- Disconnect the starter solenoid cable connector from the engine harness connector.
- Raise and support the vehicle. Lifting and Jacking the Vehicle (Base)Lifting and Jacking the Vehicle (V-Series)
- Reposition the heated oxygen sensor connector. <p01>
- Engine Mount Bracket - Remove - Engine Mount Bracket Replacement - Left Side (LF4)
- Turbocharger Oil Return Pipe - Remove - Turbocharger Oil Return Pipe Replacement (Bank 1)Turbocharger Oil Return Pipe Replacement (Bank 2)
- Starter Heat Shield - Remove - Starter Shield Replacement (LF4)
- Support the transmission with a suitable jack.
- - Remove - Transmission Support Replacement (Automatic RWD)Transmission Support Replacement (Automatic AWD)Transmission Support Replacement (Manual)
- At Transmission - Remove - Two-Piece Propeller Shaft Replacement (LF4)
- Range Selector Lever Cable - Remove - Range Selector Lever Cable Replacement
- Lower the transmission.
- Starter Solenoid Cable Retainer Bolt - Remove
- Starter Mounting Bolt - Remove <p01>
- Lower the starter to access the electrical connections.
- Starter Solenoid Connector - Disconnect
- Starter Solenoid Cable Nut - Remove
- Starter Solenoid Cable - Remove
- Starter - Remove