Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Multifunction Energy Storage Capacitor - Install
- Multifunction Energy Storage Capacitor Fastener - Tighten 9 N.m (80 lb in)
- Electrical Connector Connect
- Auxiliary Generator Battery Jumper Cable - Install
- Auxiliary Generator Battery Jumper Cable Nut - Tighten 12 N.m (106 lb in)
- Ground Cable - Install
- Ground Cable Nut - Tighten 12 N.m (106 lb in)
- Protective Cap - Install
- Rear Bumper Fascia Replacement -Install
- Lower the vehicle.
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection
- Perform Stop/Start Capacitor Control State Health Reset. Stop/Start Capacitor Control State of Health Reset
CAUTION:
Refer to Fastener Caution .