Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Battery Negative Cable Clamp Fastener

Courtesy of GENERAL MOTORS COMPANY

Battery Negative Cable - Install

CAUTION:

Refer to Fastener Caution .

Battery Negative Post Clamp Nut - Tighten 7 N.m (62 lb in)

Fig 2: Battery Access Cover Located At Left Rear Compartment Area

Courtesy of GENERAL MOTORS COMPANY

Access Cover - Close

NOTE:

The Sop/Start feature will not be available until the vehicle is allowed to sit for at least 3 hours undisturbed. If diagnosing a Stop/Start complaint, conduct the battery sensor module learn procedure to verify the repair.

Perform the battery sensor module learn procedure. Refer to Battery Sensor Module Learn