LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Battery, Charging System And Starting System) >> Repair Instructions >> Auxiliary Generator Battery Jumper Cable Replacement (KL9) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Command the Discharge Start/Stop Capacitor parameter with the scan tool and discharge the multifunction energy storage capacitor. Wait 3 minutes for the capacitor to discharge.
  2. Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection 
  3. Lifting and Jacking the Vehicle (Base)Lifting and Jacking the Vehicle (V-Series)
  4. Rear Bumper Fascia Replacement -Remove
    5. Fig 1: Ground Cable Nut
    GM4088505Courtesy of GENERAL MOTORS COMPANY
  5. Ground Cable Nut - Remove
  6. Ground Cable - Remove
  7. Protective Cap - Remove
  8. Auxiliary Generator Battery Jumper Cable Nut - Remove
  9. Auxiliary Generator Battery Jumper Cable - Remove
  10. Lower the vehicle.
  11. Rear Compartment Side Trim Replacement - Left Side (Sedan with AM9)Rear Compartment Side Trim Replacement - Left Side (Sedan except AM9)Rear Compartment Side Trim Replacement - Left Side (Coupe) -Remove
    12. Fig 2: Auxiliary Generator Battery Jumper Cable
    GM4089442Courtesy of GENERAL MOTORS COMPANY
  12. Remove the cable grommet from the floor panel.
  13. Retainer - Disconnect
  14. Auxiliary Generator Battery Jumper Cable - Remove
    15. Fig 3: Auxiliary Generator Battery Jumper Cable
    GM4089432Courtesy of GENERAL MOTORS COMPANY
  15. Auxiliary Generator Battery Jumper Cable Nut - Remove
  16. Auxiliary Generator Battery Jumper Cable Nut - Remove
  17. Auxiliary Generator Battery Jumper Cable - Remove
    18. Fig 4: Active Safety Control Module
    GM4262463Courtesy of GENERAL MOTORS COMPANY
  18. { If equipped } Active Safety Control Module Bracket Bolt - Remove
  19. { If equipped }Active Safety Control Module Bracket - Reposition away
    20. Fig 5: Multifunction Energy Storage Capacitor Control Module
    GM4087148Courtesy of GENERAL MOTORS COMPANY
  20. Multifunction Energy Storage Capacitor Control Module Bracket Bolt 1 - Remove
  21. Multifunction Energy Storage Capacitor Control Module Bracket Bolt 2 - Remove
    22. Fig 6: Auxiliary Generator Battery Jumper Cable
    GM4089435Courtesy of GENERAL MOTORS COMPANY
  22. Auxiliary Generator Battery Jumper Cable Nut - Remove1
  23. Auxiliary Generator Battery Jumper Cable - Remove 2
scientia non olet · About LEMON Manuals