Inspection Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (ATS)Lifting and Jacking the Vehicle (ATS-V) .
- Clean any dirt from around the differential fill plug (1).
- Remove the fill plug (1) from the differential.
- Check the differential fluid level, it should be even with the bottom of the fill plug hole to no lower than 2 mm (0.08 in) below the opening.
- Add new fluid if necessary. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the differential fill plug (1) to the differential and tighten to 33 N.m (24 lb ft).
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .