LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Engine Mechanical - 2.0L (LTG) - Specifications) >> Specifications >> Fastener Specifications (LCV)

Fastener Specifications (LCV)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Application
Camshaft Cover Gasket
Combustion Fuel Injector Seal
Connecting Rod Bearing
Crankshaft Front Oil Seal
Crankshaft Rear Oil Seal
Cylinder Head Gasket
Cylinder Head Oil Gallery Plug
Engine Coolant Thermostat Housing Gasket
Exhaust Manifold Gasket
Fuel Feed Intermediate Pipe
Fuel Injection Fuel Rail Seal
Fuel Injector Seal Ring
Fuel Injector Spacer
Fuel Pump Gasket
Fuel Pump Housing Seal
Intake Manifold Gasket
Oil Pan Gasket
Piston Pin Retainer
Thermostat Bypass Pipe Gasket
Throttle Body Gasket
Timing Chain Tensioner Seal
Vacuum Pump Gasket
Vacuum Pump Seal
Valve Stem Oil Seal
Water Outlet Gasket
Water Pump Gasket
Single Use Threaded Fastener/Component Tightening Specifications

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Application Specification
Metric (English)
Automatic Transmission Flex Plate Bolt
  • First Pass:
 30 N.m (22 lb ft)
  • Final Pass:
 40 degrees
Balance Shaft Sprocket Bolt
  • First Pass:
 40 N.m (30 lb ft)
  • Final Pass:
 50 degrees
Camshaft Position Actuator Bolt
  • First Pass:
 30 N.m (22 lb ft)
  • Final Pass:
 100 degrees
Connecting Rod Bolt
  • First Pass:
 25 N.m (18 lb ft)
  • Final Pass:
 110 degrees
Crankshaft Balancer Bolt
  • First Pass:
 150 N.m (111 lb ft)
  • Final Pass:
 140 degrees
Cylinder Head Bolt
  • First Pass:
 30 N.m (22 lb ft)
  • Final Pass:
 190 degrees
Cylinder Head Core Hole Plug 50 N.m (37 lb ft)
Engine Flywheel Bolt
  • First Pass:
 30 N.m (22 lb ft)
  • Final Pass:
 80 degrees
Engine Front Cover Bolt - M10
  • First Pass:
 15 N.m (11 lb ft)
  • Final Pass:
 130 degrees
Engine Mount Bolt
  • First Pass:
 58 N.m (43 lb ft)
  • Final Pass:
 60-75 degrees
Exhaust Manifold Bolt 20 N.m (15 lb ft)
Fuel Feed Intermediate Pipe Nut
  • First Pass:
 15 N.m (11 lb ft)
  • Final Pass:
 30 N.m (22 lb ft)
Fuel Pump Bolt
  • First Pass:
 8 N.m (71 lb in)
  • Final Pass:
 50 degrees
Lower Crankcase Bolt
  • First Pass:
 20 N.m (15 lb ft)
  • Final Pass:
 140 degrees
Oil Filter 3/4 to 1 full turn after gasket makes contact with the sealing surface on the filter mounting flange
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal. 
Application Specification
Metric (English)
Balance Chain Guide Bolt 10 N.m (89 lb in)
Balancer Chain Tensioner Bolt 10 N.m (89 lb in)
Balancer Shaft with Oil Pump Bolt
  • First Pass:
 58 N.m (43 lb ft)
  • Final Pass:
 58 N.m (43 lb ft)
Camshaft Bearing Cap Bolt 10 N.m (89 lb in)
Camshaft Bearing Cap Bolt - Front 10 N.m (89 lb in)
Camshaft Cover Bolt 10 N.m (89 lb in)
Camshaft Cover Heat Shield Bolt 10 N.m (89 lb in)
Camshaft Cover Opening Plug 35 N.m (26 lb ft)
Camshaft Position Actuator Solenoid Valve Bolt 10 N.m (89 lb in)
Camshaft Position Sensor Bolt 10 N.m (89 lb in)
Crankshaft Position Sensor Bolt 10 N.m (89 lb in)
Cylinder Head Oil Gallery Plug 40 N.m (30 lb ft)
Drive Belt Tensioner Bolt 58 N.m (43 lb ft)
Engine Block Oil Gallery Plug 65 N.m (48 lb ft)
Engine Block Oil Gallery Plug 40 N.m (30 lb ft)
Engine Coolant Air Bleed Pipe Bolt 10 N.m (89 lb in)
Engine Coolant Heater 50 N.m (37 lb ft)
Engine Coolant Heater Hole Plug 60 N.m (44 lb ft)
Engine Coolant Thermostat Housing Bolt 10 N.m (89 lb in)
Engine Front Cover Bolt - M6 10 N.m (89 lb in)
Engine Front Cover Bolt - M8 25 N.m (18 lb ft)
Engine Lift Front Bracket Bolt 25 N.m (18 lb ft)
Engine Lift Rear Bracket Bolt 25 N.m (18 lb ft)
Engine Mount Bracket Bolt 58 N.m (43 lb ft)
Engine Mount Bracket Nut 70 N.m (52 lb ft)
Engine Mount Vacuum Hose Fastener 9 N.m (80 lb in)
Engine Mount Vacuum Tank Fastener 9 N.m (80 lb in)
Engine Mount Vacuum Valve Fastener 9 N.m (80 lb in)
Engine Oil Level Indicator Switch Bolt 10 N.m (89 lb in)
Engine Oil Pressure Sensor 35 N.m (26 lb ft)
Exhaust Bracket Bolt 10 N.m (89 lb in)
Exhaust Manifold Heat Shield Bolt 14 N.m (124 lb in)
Fuel Injection Fuel Rail Bolt 25 N.m (18 lb ft)
Fuel Injection Fuel Rail Fuel Pressure Sensor 33 N.m (24 lb ft)
Fuel Pump Shield Bolt 10 N.m (89 lb in)
Ignition Coil Bolt 10 N.m (89 lb in)
Intake Manifold Bolt 12 N.m (106 lb in)
Intake Manifold Bracket Bolt - Upper 10 N.m (89 lb in)
Intake Manifold Cover Bolt 9 N.m (80 lb in)
Knock Sensor Bolt 25 N.m (18 lb ft)
Lower Crankcase Bolt 25 N.m (18 lb ft)
Lower Oil Pan Bolt 10 N.m (89 lb in)
Manifold Absolute Pressure Sensor Bolt 5 N.m (44 lb in)
Oil Filter Fitting 50 N.m (37 lb ft)
Oil Pan Bolt 10 N.m (89 lb in)
Oil Pan Bolt 25 N.m (18 lb ft)
Oil Pan Drain Plug 25 N.m (18 lb ft)
Oil Pump Flow Control Valve Bolt 10 N.m (89 lb in)
Oil Pump Flow Control Valve Heat Shield Fastener 9 N.m (80 lb in)
Oil Pump Flow Control Valve Heat Shield Fastener 58 N.m (43 lb ft)
Oxygen Sensor 42 N.m (31 lb ft)
Piston Oil Nozzle Bolt 10 N.m (89 lb in)
Positive Crankcase Ventilation Valve Bolt 10 N.m (89 lb in)
Radiator Inlet Pipe Bolt 10 N.m (89 lb in)
Thermostat Bypass Pipe Bolt 10 N.m (89 lb in)
Throttle Body Bolt 10 N.m (89 lb in)
Timing Chain Guide Bolt 25 N.m (18 lb ft)
Timing Chain Tensioner Bolt 25 N.m (18 lb ft)
Timing Chain Tensioner Shoe Bolt 25 N.m (18 lb ft)
Transmission Bolt @ Oil Pan 50 N.m (37 lb ft)
Vacuum Pump Bolt 10 N.m (89 lb in)
Water Outlet Bolt 12 N.m (106 lb in)
Water Pump Bolt 25 N.m (18 lb ft)
scientia non olet · About LEMON Manuals