Fastener Specifications
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Axle Shaft Retaining Ring |
| CV Boot Retaining Clamp |
| Intermediate Shaft O-Ring |
| Intermediate Shaft Retaining Ring |
| Wheel Drive Shaft Washers |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Wheel Drive Shaft Nut | 250 N.m (185 lb ft) |
| Torque Prevailing Rear Wheel Drive Shaft Nut | 250 N.m (185 lb ft) |
| Wheel Drive Shaft Bolt | |
| First Pass: | 50 N.m (37 lb ft) |
| Final Pass: | 45 degrees |