LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (Non V-Series With AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    Ensure the front stabilizer shaft insulators are aligned the as noted before transferring.

    Fig 1: Front Stabilizer Shaft
    GM4592607Courtesy of GENERAL MOTORS COMPANY
  1. Position the front stabilizer shaft (1) on the drivetrain and front suspension frame.
    2. Fig 2: Front Stabilizer Shaft Insulator Clamps And Nuts
    GM4592605Courtesy of GENERAL MOTORS COMPANY
  2. Install the front stabilizer shaft insulator clamps (2) at each side.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the front stabilizer shaft insulator clamp nuts (1) at each side and tighten to 22 N.m (16 lb ft).
  4. Completely install the drivetrain and front suspension frame. Refer to Drivetrain and Front Suspension Frame Removal and Installation (LGX, LTG)
  5. Measure and adjust the wheel alignment. Refer to Wheel Alignment Measurement
scientia non olet · About LEMON Manuals