Stabilizer Shaft Insulator Replacement (Non V-Series With AWD Only)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stabilizer Shaft Insulator (Non V-Series With AWD)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove Engine Compartment Lower Noise Shield. Refer to Engine Compartment Lower Noise Shield Replacement (All Wheel Drive) Remove Front Wheelhouse Splash Shield (Qty: 2). Refer to Front Wheelhouse Splash Shield Replacement (All Wheel Drive) Separate Front Stabilizer Shaft Link (Qty: 2) @ Front Stabilizer Shaft. Refer to Stabilizer Shaft Link Replacement (Non V-Series)
1	Front Stabilizer Shaft Insulator Clamp Nut (Qty: 2) CAUTION: Refer to Fastener Caution . Procedure Loosen the front stabilizer shaft insulator clamp nuts on the opposite side being serviced to aid in moving the front stabilizer shaft. Tighten 22 N.m (16 lb ft)
2	Front Stabilizer Shaft Insulator Clamp
3	Front Stabilizer Shaft Insulator NOTE: Ensure the NEW front stabilizer shaft insulator is aligned the same way as the OLD insulator before installing.