Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- If replacing hose then transfer the fuel tank pressure sensor. Refer to Fuel Tank Pressure Sensor Replacement .
- Install the fuel tank vent hose (4) to the EVAP emission canister. Refer to Plastic Collar Quick Connect Fitting Service .
- Install the fuel tank vent hose (4) to the retainers (3).
- Install the fuel tank vent hose (4) to the fuel tank filler pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
- Install NEW tie straps (1) to attach the fuel tank vent hose to the fuel tank filler pipe.
- Connect the fuel tank pressure sensor electrical connector.
- Install the right rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement (Non V-Series)Rear Wheelhouse Liner Replacement (V-Series) .
- Connect the fuel tank vent hose (1) to the fuel tank vent valve hose. Refer to Plastic Collar Quick Connect Fitting Service .
- Lower the vehicle.