Fuel Feed Pipe Replacement (Chassis Fuel Feed Pipe to High Pressure Fuel Pump)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Feed Pipe (Chassis Fuel Feed Pipe to High Pressure Fuel Pump)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to Gasoline/Gasoline Vapors Warning . Preliminary Procedure Intake Manifold Cover Replacement WARNING: The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death. Remove the outer fuel pump insulator. Fuel Pump Insulator Replacement (Inner) Fuel Pump Insulator Replacement (Outer) Fuel Pressure Relief
1	Fuel Feed Pipe Bracket Fastener CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Fuel Feed Pipe Fitting CAUTION: Refer to Component Fastener Tightening Caution . Procedure Hand start the NEW fuel feed pipe fitting. First Pass:15 N.m (11 lb ft) Final Pass:30 N.m (22 lb ft)
3	Fuel Feed Pipe Procedure Quick Connect Fitting»Disconnect Metal Collar Quick Connect Fitting Service NOTE: The fuel feed pipe fitting is one time use, always install a NEW fuel feed pipe.