Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the evaporative emission pipe (1) to the vehicle.
- Connect the evaporative emission pipe (1) and install to the retainers (2). Refer to Plastic Collar Quick Connect Fitting Service .
- Install the front body exhaust heat shield right side. Refer to Front Body Exhaust Heat Shield Replacement (Right)Front Body Exhaust Heat Shield Replacement (Left) .
- Install the underbody front air deflector right side. Refer to Underbody Front Air Deflector Replacement - Right Side .
- Lower the vehicle.
- Install the evaporative emission pipe (1) to the evaporative emission canister purge solenoid valve and retainers. Refer to Plastic Collar Quick Connect Fitting Service .
- Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .