LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Engine Controls And Fuel - 2.0L (LTG) - Repair Instructions) >> Repair Instructions >> Charge Air Cooler Inlet Air Tube Replacement (LTG) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (LTG) .
  2. Loosen the clamp and disconnect the charge air cooler inlet air tube from the inlet air hose.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (ATS)Lifting and Jacking the Vehicle (ATS-V) .
  4. Remove the engine compartment lower noise shield. Refer to Engine Compartment Lower Noise Shield Replacement (All Wheel Drive)Engine Compartment Lower Noise Shield Replacement (Front Wheel Drive) .
  5. Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Non V-Series)Front Wheelhouse Liner Replacement (V-Series) .
    6. Fig 1: Charge Air Cooler Inlet Air Tube
    GM2873830Courtesy of GENERAL MOTORS COMPANY
  6. Remove the charge air cooler inlet air tube bolts (1) from the charge air cooler inlet air tube (2).
  7. Lower the vehicle.
  8. Remove the charge air cooler inlet air tube from the turbocharger.
    9. Fig 2: Charge Air Cooler Inlet Air Tube
    GM2873828Courtesy of GENERAL MOTORS COMPANY
  9. Pull the release clip (1) outward and disconnect the charge air cooler inlet air tube (2) from the charge air cooler.
  10. Remove the charge air cooler inlet air tube (2) from the vehicle.
scientia non olet · About LEMON Manuals