Fastener Specifications (M3L)
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Counter Gear Bearing Shim |
| Input Shaft Bearing Shim |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Clutch Housing Bolt/Screw | 33 N.m (24 lb ft) |
| Engine to Clutch Housing Fasteners | 50 N.m (37 lb ft) |
| Extension Housing Bolt/Screw | 33 N.m (24 lb ft) |
| Manual Shift Detent Bolt | 22 N.m (16 lb ft) |
| Manual Transmission Selector Lever Pivot Pin (5th Gear) | 41 N.m (30 lb ft) |
| Neutral Position Sensor Bolt/Screw - Model Dependent | 11 N.m (97 lb in) |
| Propeller Shaft Transmission Yoke Nut | 143 N.m (106 lb ft) |
| Reverse Sensor | 27 N.m (20 lb ft) |
| Shift Control Assembly Fasteners | 18 N.m (13 lb ft) |
| Shift Control Shaft Position Guide Bolt/Screw | 12 N.m (106 lb in) |
| Shift Shaft Detent Plug | 22 N.m (16 lb ft) |
| Shift Interlock Detent Assembly | 41 N.m (30 lb ft) |
| Shift Interlock Plate Retainer Bolt | 25 N.m (18 lb ft) |
| Shift Shaft Detent Spring Cover Bolt | 28 N.m (21 lb ft) |
| Transmission Control Lever Knob Fastener | 7 N.m (62 lb in) |
| Transmission Mount (Mount to Transmission) | 58 N.m (43 lb ft) |
| Transmission Mount (Mount to Transmission Support) | 58 N.m (43 lb ft) |
| Oil Drain Plug | 27 N.m (20 lb ft) |
| Oil Fill Plug | 27 N.m (20 lb ft) |
| Transmission Speed Sensor Bolt/Screw | 10 N.m (89 lb in) |
| Transmission Support Fasteners | 60 N.m (44 lb ft) |