Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the vehicle speed sensor (2) with a NEW O-ring seal.
- Install the vehicle speed sensor bolt (1) and tighten to 10 N.m (89 lb in).
- Connect the vehicle speed sensor electrical connector (2).
- Lower the vehicle.
NOTE:
Verify the NEW or old sensor is equipped with a NEW O-ring, DO NOT reuse the old O-ring seal.
CAUTION:
Refer to Fastener Caution .