Transmission Fluid Level Inspection (MG9)
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (ATS-V) .
- Disconnect the clip (1) retaining the cooler pipe to the transmission bracket.
- Reposition the cooler pipe to allow access to the fill plug.
- Remove the transmission fill plug from the transmission.
- For fluid recommendations, Refer to Adhesives, Fluids, Lubricants, and Sealers (MG9)
Transmission fluid level MUST be 3.2 mm (1/8 inch) below (1) the fill plug. This can be done by one of the following methods:
- Bend mechanics wire to 3.2 mm (1/8 inch) to check fluid level. Add or remove fluid as necessary.
- Fill transmission until level with the bottom of the fill plug hole, then remove 240 ml (8 ounces) of fluid.
- Install the transmission fill plug to the transmission and tighten to 27 N.m (20 lb ft).
- Reconnect the clip (1) retaining the cooler pipe to the transmission bracket.
- Run the engine in Neutral for two minutes to allow the fluid to recirculate.
- Remove the fill plug and verify the fluid level is 3.2 mm (1/8 inch) below the fill plug hole. Add or remove transmission fluid as necessary.
- Install the transmission fill plug to the transmission and tighten to 27 N.m (20 lb ft).
- Lower the vehicle.
IMPORTANT:
Transmission fluid level setting must be followed exactly as written or the transmission may be overfilled or under filled.
CAUTION:
Refer to Fastener Caution .
NOTE:
Inspect the clip for proper retention on the cooler line to the bracket. Replace the clip as necessary.
NOTE:
Ensure the clutch pedal is NOT depressed.