Extension Housing Removal
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the DT-47678 flange (2) and the DT-47678-10 flange adapter (3).
- Mount the transmission on a workbench using the J-3289-20 holding fixture (1).
- Rotate the transmission into a horizontal position.
- Remove the transmission drain plug and drain the transmission fluid.
- Shift the transmission into NEUTRAL (N).
- Remove the shifter cover plate bolts (3).
- Remove the shifter cover plate (2) and gasket (1).
- Install the J-45012 holding fixture with the mounting bolts to the propeller shaft transmission yoke (3).
- Using a socket wrench, remove the propeller shaft transmission yoke nut (1).
- Remove the propeller shaft transmission yoke washer (2).
- Using DT-45019 flange and pinion cage remover, remove the propeller shaft transmission yoke (1).
- Remove the manual transmission gear position sensor bolt (1).
- Remove the manual transmission gear position sensor (2) and the manual transmission gear position sensor gasket (3).
- Remove the transmission gap magnet bolt (1) and the transmission gap magnet (2).
- Remove the rear extension housing bolts (1), nuts (2), and the brackets (3, 4).
- Remove the extension housing (5) and transmission extension gasket (6).