Inverter Lever Install

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Housing Bolts

Courtesy of GENERAL MOTORS COMPANY

Temporarily remove the clutch housing bolts (1).

Fig 2: Clutch Housing Assembly

Courtesy of GENERAL MOTORS COMPANY

Temporarily remove the clutch housing assembly (1).

Fig 3: Manual Transmission Selector Lever

Courtesy of GENERAL MOTORS COMPANY

Install the manual transmission selector lever (1).

Fig 4: Manual Transmission Selector Lever Pivot Pin

Courtesy of GENERAL MOTORS COMPANY

Install the manual transmission selector lever pivot pin (1). Tighten to 41 N.m (30 lb ft). Refer to Adhesives, Fluids, Lubricants, and Sealers (M3L)

Fig 5: Manual Transmission Shift Lever Retainer

Courtesy of GENERAL MOTORS COMPANY

Install the manual transmission shift lever retainer (1).

Fig 6: Clutch Housing Sealant Application Area

Courtesy of GENERAL MOTORS COMPANY

Apply a 1.7 mm (0.07 in) bead of RTV sealant (1) to the clutch housing. Refer to Adhesives, Fluids, Lubricants, and Sealers (M3L)

Fig 7: Clutch Housing Assembly

Courtesy of GENERAL MOTORS COMPANY

Install the clutch housing assembly (1)

Fig 8: Clutch Housing Bolts

Courtesy of GENERAL MOTORS COMPANY

Install the clutch housing bolts (1). Tighten to 33 N.m (24 lb ft).