Extension Housing Install
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Apply a 1.7 mm (0.07 in) bead of RTV sealant (1) to the extension housing. Refer to Adhesives, Fluids, Lubricants, and Sealers (M3L)
- Install the O-ring (1) onto the propeller shaft.
- Install the extension housing assembly (2), the extension housing stud (4), and the extension housing bolts (3). Tighten the bolts and stud to 33 N.m (24 lb ft).
- Install the manual shift detent bolt (1), detent spring (2) and the detent (3).
- Apply thread sealant to the detent bolt (1). Refer to Adhesives, Fluids, Lubricants, and Sealers (M3L)
Tighten the bolt to 28 N.m (21 lb ft).
- Install the shift interlock detent assembly (1).
- Apply thread sealant to the detent (1). Refer to Adhesives, Fluids, Lubricants, and Sealers (M3L)
Tighten to 41 N.m (30 lb ft)
- Install the manual transmission control lever seal (5).
- Install the manual transmission shift lever shaft joint (3) and manual transmission control lever pin (4).
- Install the manual transmission control lever retainer (2) and manual transmission control shaft boot (1).
- Using DT-39441 installer, install the propeller shaft transmission yoke (1).
- Install the propeller shaft transmission yoke flange washer (2).
- Install the J-45012 holder with the mounting bolts to the propshaft transmission yoke (3).
- Apply threadlocker to the nut (1). Refer to Adhesives, Fluids, Lubricants, and Sealers (M3L)
- Using a socket wrench, Install the propeller shaft transmission yoke nut (1) and tighten to 140 N.m (103 lb ft).
- Remove the J-45012 holder.