Circuit/System Verification
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition On/Vehicle In Service Mode
- Perform the scan tool control function: Reverse Inhibit Solenoid Actuator On and Off
Verify a click can be heard or felt at the component when it is turned On and Off: M47 Reverse Inhibit Solenoid Actuator
- If a click cannot be heard or felt
Refer to: Circuit/System Testing
- If a click can be heard or felt
- If a click cannot be heard or felt
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- If the DTC is not set
- If the DTC sets
- All OK.