Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove and discard the old O-ring seals (2) and replace with NEW O-ring seals.
- Install the oil cooler fitting (1) to the radiator and tighten to 20 N.m (15 lb ft).
- Install the transmission fluid cooler pipe(s)/hose(s) to the oil cooler fittings (1) on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
- Fill the transmission fluid to the proper level. Refer to Transmission Fluid Fill Procedure .
- Inspect for fluid leaks.
CAUTION:
Refer to Fastener Caution
NOTE:
The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.