LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Mechanical - 2.0L (LTG) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive belt. Refer to Drive Belt Replacement 
    2. Fig 1: Crankshaft Balancer Remover, Breaker Bar And Fastener
    GM3971349Courtesy of GENERAL MOTORS COMPANY
  2. Use EN-51577-1  Crankshaft Balancer Remover (1) and breaker bar (2) prevent the crankshaft from rotating while loosening the crankshaft balancer fastener (3).
  3. Remove and DISCARD the crankshaft balancer fastener (3).
    4. Fig 2: Crankshaft End Protector And Balancer Remover
    GM3971443Courtesy of GENERAL MOTORS COMPANY
  4. Remove the crankshaft balancer holder then install the J-41816-2 or EN-38416-2  Crankshaft End Protector (1) and all components of EN-51577  Crankshaft Balancer Remover (2, 3) as shown.
    5. Fig 3: Crankshaft Balancer Remover And Balancer
    GM3971380Courtesy of GENERAL MOTORS COMPANY
  5. Tighten the crankshaft balancer remover (1) in order to remove the crankshaft balancer (2).
scientia non olet · About LEMON Manuals