Camshaft Cover Heat Shield Replacement (LTG)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Cover Heat Shield (LTG)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement Remove Turbocharger Heat Shield. Refer to Turbocharger Heat Shield Replacement
1	Camshaft Heat Shield Cover Fastener (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Heat Shield Cover Procedure Disconnect the camshaft position actuator solenoid valve. Unclip the wiring harness. NOTE: When removing the camshaft cover heat shield, carefully guide the shield past the turbocharger coolant return and PCV pipes.

Callout

Component Name

Preliminary Procedures

Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
Remove Turbocharger Heat Shield. Refer to Turbocharger Heat Shield Replacement

Camshaft Heat Shield Cover Fastener (Qty: 4)

CAUTION:

Refer to Fastener Caution .

Tighten
10 N.m (89 lb in)

Camshaft Heat Shield Cover

Procedure

Disconnect the camshaft position actuator solenoid valve.
Unclip the wiring harness.

NOTE:

When removing the camshaft cover heat shield, carefully guide the shield past the turbocharger coolant return and PCV pipes.