Component Testing
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Dynamic Test
- Disconnect the harness connector at the Q80L Engine Mount Solenoid Valve-Left.
- Install a 10A fused jumper wire between the B+ terminal 2 and 12 V. Install a jumper wire between the control terminal 1 and ground.
- Verify the Q80L Engine Mount Solenoid Valve-Left turns on and off or clicks.
- If the Q80L Engine Mount Solenoid Valve-Left does not turn and off or click
Replace the Q80L Engine Mount Solenoid Valve-Left.
- If the Q80L Engine Mount Solenoid Valve-Left does turn on and off or clicks
- If the Q80L Engine Mount Solenoid Valve-Left does not turn and off or click
- All OK