Rear Compartment Lid Inner Panel Trim Replacement

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Compartment Lid Inner Panel Trim Assembly

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Refer to Rear Compartment Lid Latch Cover Replacement Refer to Rear Compartment Lid Hinge Cover Replacement
1	Rear Compartment Lid Inside Handle Fastener CAUTION: Refer to Fastener Caution . Procedure Use a small flat bladed tool to open the integral handle cover and access fastener. Tighten 2.5 N.m (22 lb in)
2	Rear Compartment Lid Inside Handle
3	Rear Compartment Lid Inner Panel Trim Retainer (Qty: 8) NOTE: Retainers are integral to backside of rear compartment lid inner panel trim.
4	Rear Compartment Lid Inner Panel Trim Procedure Use a flat bladed plastic trim tool. NOTE: Ensure the auxiliary rear compartment latch release handle is routed through the rear compartment lid inner panel trim.