Body Lock Pillar Garnish Molding Replacement (Coupe)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Body Lock Pillar Garnish Molding Assembly (Coupe)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the quarter lower rear trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Coupe) . Remove the front side door sill trim plate. Refer to Front Side Door Sill Trim Plate Replacement (Coupe) .
1	Body Lock Pillar Garnish Molding Assembly Procedure Starting at the front gently pull up on the body lock pillar garnish molding to disengage the retaining clips. Reposition the rear floor panel carpet, if required.

Callout

Component Name

Preliminary Procedures

Remove the quarter lower rear trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Coupe) .
Remove the front side door sill trim plate. Refer to Front Side Door Sill Trim Plate Replacement (Coupe) .

Body Lock Pillar Garnish Molding Assembly

Procedure

Starting at the front gently pull up on the body lock pillar garnish molding to disengage the retaining clips.
Reposition the rear floor panel carpet, if required.