Removal Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Up/Down or In/Out Adjustment
- Open the door.
- Apply masking tape to the quarter panel edge and the door edges.
Loosen the door side hinge bolts.
Do not remove the bolts from the door.
- Adjust the door up or down by repositioning the door as needed.
- Adjust the door in or out by repositioning the door as needed.
CAUTION:
Refer to Paint Damage Caution .
NOTE:
The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position.
Fore/Aft Adjustment
- Apply masking tape to the quarter panel edge and door edges.
Loosen the bodyside hinge bolts.
Do not remove the bolts from the door.
- Adjust the door fore and aft by repositioning the door as needed.
CAUTION:
Refer to Paint Damage Caution .
NOTE:
The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position.