Installation Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Starter Solenoid Cable Retainers

Courtesy of GENERAL MOTORS COMPANY

Attach the starter solenoid cable retainers (1) to the engine harness.

Fig 2: Starter Solenoid Ground Cable

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the starter solenoid cable ground (1), to the right upper tie bar frame extension rail, and tighten the fastener (2) to 11 N.m (97 lb in).
Attach the heater cord retainer (3), if equipped.

Fig 3: Pre-Fuse Block

Courtesy of GENERAL MOTORS COMPANY

Attach the following to the pre-fuse block:
- Starter Solenoid Cable (5).
- Battery Positive Cable (4).
- Battery Positive Barrel Fastener (3). Tighten to 12 N.m (106 lb in).
- Pre-Fuse Block Cover (2).
- Battery Jumper Post Cover (1).

Fig 4: Engine Coolant Heater Cord Connector And Starter Solenoid Cable

Courtesy of GENERAL MOTORS COMPANY

Install the starter solenoid cable (3) to the starter solenoid and tighten the fastener (4) to 10 N.m (89 lb in).
Install the engine coolant heater connector (1), if equipped.
Install the intake manifold. Refer to Intake Manifold Replacement .

Fig 5: Cable Ground Fastener

Courtesy of GENERAL MOTORS COMPANY

Install the starter solenoid cable ground (2), to the engine block, and tighten the fastener (1) to 45 N.m (33 lb ft).
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .