Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install Multifunction Energy Storage Capacitor (3)
- Tighten Multifunction Energy Storage Capacitor Fastener (1) (Qty: 2) to 9 N.m (80 lb in)
- Connect Electrical Connector (2)
- Install Auxiliary Generator Battery Jumper Cable (3)
- Tighten Auxiliary Generator Battery Jumper Cable Nut (2) to 12 N.m (106 lb in)
- Install Ground Cable (5)
- Tighten Ground Cable Nut (4) to 12 N.m (106 lb in)
- Install Protective Cap (1)
- Install Rear Bumper Fascia. Refer to Rear Bumper Fascia Replacement
- Lower the vehicle.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection
- Perform Stop/Start Capacitor Control State Health Reset. Refer to Stop/Start Capacitor Control State of Health Reset
CAUTION:
Refer to Fastener Caution .