LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Supplemental Restraint System) >> Diagnostic Information and Procedures >> DTC B0079 or B0080: Passenger Seat Position Sensor >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector:

  • B62P Seat Position Sensor - Passenger
  • K36 Inflatable Restraint Sensing and Diagnostic Module module
  • B62P Seat Position Sensor - Passenger wiring harness connector
  • K36 Inflatable Restraint Sensing and Diagnostic Module wiring harness connector
  1. Ignition OFF. Disconnect the harness connector at the appropriate B62P Seat Position Sensor - Passenger. It may take up to 2 minutes for all vehicle systems to power down.
  2. Test for less than 10 Ω between the low reference circuit terminal 1 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF, disconnect the X2 harness connector at the K36 Inflatable Restraint Sensing and Diagnostic Module.
    2. Test for less than 2 Ω in the low reference circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K36 Inflatable Restraint Sensing and Diagnostic Module.
    • If less than 10 Ω 
  3. Ignition ON.
  4. Test for 1-9 V between the signal circuit terminal 2 and ground.
    • If less than 1 V 
    1. Ignition OFF. Disconnect the harness connector at the K36 Inflatable Restraint Sensing and Diagnostic Module.
    2. Test for infinite resistance between the signal circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K36 Inflatable Restraint Sensing and Diagnostic Module.
    • If greater than 9 V 
    1. Ignition OFF. Disconnect the X2 harness connector at the K36 Inflatable Restraint Sensing and Diagnostic Module. Ignition ON.
    2. Test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater repair the short to voltage on the circuit.
      • If less than 1 V, replace the K36 Inflatable Restraint Sensing and Diagnostic Module.
    • If between 1-9 V 
  5. Replace the B62P Seat Position Sensor - Passenger.
scientia non olet · About LEMON Manuals