Turbocharger Coolant Return Pipe Replacement (LF4 - Bank 2)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Turbocharger Coolant Return Pipe (LF4 - Bank 2)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Drain the cooling system. Cooling System Draining and Filling (Static) Cooling System Draining and Filling (GE 47716) Turbocharger Heat Shield Replacement (LF4 Bank 2)
1	Turbocharger Coolant Return Pipe Fastener CAUTION: Refer to Fastener Caution . Procedure Clean the gasket surfaces. Install a NEW gaskets. Tighten 35 N.m (26 lb ft)
2	Turbocharger Coolant Return Pipe Retaining Clip
3	Turbocharger Coolant Return Pipe Jiffy-Tite® Fastener Procedure Remove and DISCARD the Jiffy-Tite® fastener Install a NEW Jiffy-Tite® fastener Tighten 35 N.m (26 lb ft)
4	Turbocharger Coolant Return Pipe