LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Engine Cooling System) >> Repair Instructions >> Turbocharger Coolant Feed Pipe Replacement (LTG)

Turbocharger Coolant Feed Pipe Replacement (LTG)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Turbocharger Coolant Feed Pipe (LTG)
GM2874435Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static) Cooling System Draining and Filling (GE 47716) .
  2. Remove the catalytic converter. Refer to Catalytic Converter Replacement (LTG) .
NOTE:

Replace hose clamp if necessary.

Special Tools BO-38185  Hose Clamp PliersFor equivalent regional tools, refer to Special Tools .
1 Turbocharger Coolant Feed Pipe Bolt
CAUTION:

Refer to Fastener Caution .


Tighten 
35 N.m (26 lb ft)
2 Turbocharger Coolant Feed Pipe Washer (Qty: 2)
NOTE:

Install 2 NEW washers.
3 Turbocharger Coolant Feed Pipe Fastener (Qty: 2)
Tighten 
10 N.m (89 lb in)
4 Gasket
5 Hose Clamp
6 Turbocharger Coolant Feed Pipe
scientia non olet · About LEMON Manuals