Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install Engine Coolant Fan Shroud (1) @Radiator Assembly
- Install Radiator Inlet Hose (2) @Radiator Assembly - Radiator Inlet Hose Replacement (LF4)
- Install Radiator Outlet Hose (2) @Radiator Assembly - Radiator Outlet Hose Replacement (LF4)
- Install Transmission Fluid Cooler Pipe (2) @Radiator Assembly - Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LF4 With MG9)Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LF4 With M5U)
- Secure Transmission Fluid Cooler Pipe (2)
- Install Engine Coolant Fan Shroud Bolt (1) @Radiator Assembly and tighten 9 N.m (80 lb in)
- Secure Engine Mount Vacuum Filter (1) @Engine Coolant Fan Shroud - Engine Mount Vacuum Filter Replacement
- Install Push Pin (1) @Radiator Assembly
- Connect the electrical connector.(2)
- Install Air Cleaner Assembly (1) - Air Cleaner Assembly Replacement (LF4)
- Install Air Cleaner Outlet Front Duct (3) - Air Cleaner Outlet Front Duct Replacement (LF4)
- Install Front Compartment Front Sight Shield (4) - Front Compartment Front Sight Shield Replacement (ATS-V)
- Raise and support the vehicle. Lifting and Jacking the Vehicle (ATS-V)
- Secure Transmission Fluid Cooler Pipe@Engine Coolant Fan Shroud (2)
- Install Engine Coolant Fan Shroud Bolt (1) @Radiator Assembly and tighten 9 N.m (80 lb in)
- Install Front Air Deflector (5) - Front Air Deflector Replacement
- Remove the supports and lower the vehicle.
- Fill the cooling system to the proper level. Cooling System Draining and Filling (Static) Cooling System Draining and Filling (GE 47716)
- Fill and inspect the transmission fluid level.
- Start the engine and inspect for leaks.
CAUTION:
Refer to Fastener Caution .