Valve Lifter Installation - Right Side (LGX)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Valve Lifter - Right Side (LGX)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Fill the adjusters with clean engine oil. Refer to Adhesives, Fluids, Lubricants, and Sealers (LGX) for recommended engine oil. Take precautions to prevent scratching the pivot sphere area of the. Lubricate the adjusters bores in the cylinder head with clean engine oil. Install the adjusters in the cylinder head. Apply a liberal amount of lubricant to the adjusters pivot spheres. NOTE: Do not stroke/cycle the adjusters without oil in the lower pressure chamber. Do not allow the adjusters to tip over, plunger down, after the oil fill.
1	Dual Feed Hydraulic Valve Adjuster (Qty: 4)
2	Hydraulic Valve Lash Adjuster (Qty: 8)

Callout

Component Name

Preliminary Procedure

Fill the adjusters with clean engine oil. Refer to Adhesives, Fluids, Lubricants, and Sealers (LGX) for recommended engine oil. Take precautions to prevent scratching the pivot sphere area of the.
Lubricate the adjusters bores in the cylinder head with clean engine oil.
Install the adjusters in the cylinder head.
Apply a liberal amount of lubricant to the adjusters pivot spheres.

NOTE:

Do not stroke/cycle the adjusters without oil in the lower pressure chamber.
Do not allow the adjusters to tip over, plunger down, after the oil fill.

Dual Feed Hydraulic Valve Adjuster (Qty: 4)

Hydraulic Valve Lash Adjuster (Qty: 8)