Engine Flywheel Removal (LF4)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

EN-46106 Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools (LF4) .

Fig 1: Engine Flywheel

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Note the position and direction of the engine flywheel before removal. The flywheel does not use a locating pin for alignment. Mark or scribe the end of the crankshaft and the flywheel before component removal. The existing manual transmission engine flywheel must be installed to the original position and direction.

Mark or scribe the end of the crankshaft and the manual transmission flywheel.

Fig 2: Flywheel Holding Tool

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the EN-46106 and bolts.

Fig 3: Flywheel And Bolts

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Do NOT reuse the flywheel bolts.

Remove and discard the flywheel bolts (2).
Remove the manual transmission flywheel (1).
Note the location of the manual transmission flywheel balance weights, if applicable.
Remove the EN-46106 .