Cylinder Head Installation - Left Side (LGX)
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Fuel Injection Fuel Rail Noise Shield
WARNING:
The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death. |
| 2 | Cylinder Head Locating Pin
NOTE:
Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face. |
| 3 | Cylinder Head Gasket
NOTE:
Install a NEW gasket. |
| 4 | Cylinder Head |
| 5 | Cylinder Head Bolt - M8 x 80.8 (Qty: 2)
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Tighten in sequence
Special Tools EN-45059 Angle Meter Equivalent regional tools: Special Tools (LGX) . |
| 6 | Cylinder Head Bolt - M11 x 178 (Qty: 8) Tighten in sequence
|
| 7 | Fuel Injector Wiring Harness Bracket |
| 8 | Fuel Injector Wiring Harness Bracket Bolt Tighten 10 N.m (89 lb in) |