Circuit/System Verification
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Verify engine oil level and engine oil pressure are within the specified ranges. Refer to Oil Pressure Diagnosis and Testing
- If not within specified ranges
Repair as necessary.
- If within specified ranges
- If not within specified ranges
- Engine idling.
- Verify the parameters listed below do not display Malfunction.
- Cylinder 2 or 5 Deactivation Solenoid Valve Control Circuit High Voltage Test Status
- Cylinder 2 or 5 Deactivation Solenoid Valve Control Circuit Open Test Status
- Cylinder 2 or 5 Deactivation Solenoid Valve Control Circuit Low Voltage Test Status
- If Malfunction is displayed
Refer to Circuit/System Testing.
- If Malfunction is not displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If a DTC set
Refer to Circuit/System Testing.
- If a DTC does not set
- If a DTC set
- All OK.
NOTE:
DTC P3409, P3411, P3433, and P3435 will set with an open ignition circuit fuse.