Component Testing
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Charge Air Cooler Coolant Pump Dynamic Test
- Ignition ON.
- Install a jumper wire between the B+ terminal 5 and the enable circuit terminal 1. Install a 10 A fused jumper wire between the B+ circuit terminal 5 and 12 V. Install a jumper wire between the ground circuit terminal 4 and ground.
- Verify the M10 Charge Air Cooler Coolant Pump activates.
- If the pump does not activate
Replace the M10 Charge Air Cooler Coolant Pump.
- If the pump activates
- If the pump does not activate
- All OK