LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Engine Controls And Fuel - 3.6L (LGX LF4) - Repair Instructions) >> Repair Instructions >> Oil Pump Flow Control Solenoid Valve Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Wiring Harness, Oil Pump Flow Control Solenoid Valve Harness And Bolt
    GM4260770Courtesy of GENERAL MOTORS COMPANY
  1. Using the mechanics wire, guide the oil pump flow control solenoid valve harness (3) into place, then remove the wire.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install and tighten Oil Pump Flow Control Solenoid Valve Harness Bolt (2) to 15 N.m (11 lb ft)
  3. Connect Engine Wiring Harness (1)
    4. Fig 2: Oil Pump Flow Control Solenoid Valve, Harness, Crankshaft Oil Deflector And Retainers
    GM4260746Courtesy of GENERAL MOTORS COMPANY
  4. Install Oil Pump Flow Control Solenoid Valve Harness (1) @ Crankshaft Oil Deflector (4)
  5. Install Oil Pump Flow Control Solenoid Valve Harness (1) @ Retainer (3)
  6. Connect Oil Pump Flow Control Solenoid Valve Harness (1) @ Oil Pump Flow Control Solenoid Valve (2)
  7. Install Lower Oil Pan. Refer to Lower Oil Pan Replacement (AWD)Lower Oil Pan Replacement (RWD)
  8. Install Front Compartment Lower Noise Shield. Refer to Front Compartment Lower Noise Shield Replacement (Front Wheel Drive)Front Compartment Lower Noise Shield Replacement (All Wheel Drive)
scientia non olet · About LEMON Manuals